Installation instructions
Any electrical and/or plumbing work required to install
Water supply connections
this appliance should be carried out by a qualified
electrician and/or plumber or competent person.This dishwasher must be plumbed into a cold water supply.
For making the connection itself, the coupling nut fitted to the
Remove all packaging before positioning the machine.
machineOs supply hose is designed to screw onto either a 3/4"
If possible, position the machine next to a water tap and a
inch gas thread spout or to a purpose made quick-coupling tap
drain.
such as the Press-block.
The water pressure must be within the limits given in the
"Technical specifications". Your local Water Authority will
Fitting under a counter advise you on the average mains pressure in your area.
(kitchen worktop or sink)The water inlet hose must not be kinked, crushed, or entangled
when it is being connected up.
By removing the machineOs worktop, you can install it under a
The dishwasher features fill and drain hoses which can be
close fitting sink unit or a pre-existing top, providing the
turned either to the left or the right to suit the installation by
dimensions of the recess correspond to those shown in the
means of the locknut. The locknut must be correctly fitted
picture.
to avoid water leaks. (Attention! NOTall models of
dishwashers have fill and drain hoses provided with locknut. In
this case, this kind of facility is not possible).
570-600
If the machine is connected to new pipes or pipes which have
not been used for a long time, you should run the water for a
few minutes before connecting the inlet hose.
820Do not use, for connection, old hoses which have been
used in another appliance.
450
The dishwasher is fitted with safety devices that prevent the
wash water returning into the drinking water system and
IN04comply with the applicable plumbing regulations.
Proceed as follows:
Remove the machineOs worktop by unscrewing the two rear
retaining screws, pull the worktop from the back of the
machine and slide out the front slots, lifting the worktop.
Insert the machine after adjusting height and levelling with the
adjustable feet. When inserting the machine, ensure that the
water inlet and drain hoses are not kinked or squashed.
During all operations that involve accessibility to internal
components the dishwasher has to be unplugged.
Be sure that once the appliance has been installed, it is easily
accessible for the consumer service department.
If the dishwasher is later used as a free-standing appliance,
the original worktop must be re-mounted.
The plinth on free-standing appliances is not adjustable.
Levelling
Good levelling is essential for correct closure and sealing of
the door.
When the appliance is correctly levelled, the door will not catch
on either side of the cabinet.
If the door does not close correctly, loosen or tighten the
adjustable feet until the machine is perfectly level.
17 |
ACEC
